Noise analysis of an electro-optic sensor system

Optical Review - This paper describes the noise analysis of an electro-optic (EO) sensor system based on experimental and simulation results. We developed a polarization simulator of the EO sensor...     

Design of highly nonlinear dispersion flattened hexagonal photonic crystal fibers for dental optical coherence tomography applications

In this paper, we propose a highly nonlinear dispersion flattened hexagonal photonic crystal fiber (HNDF-HPCF) with nonlinear coefficients as large as 57.5W⁻¹ km⁻¹ at 1.31 μm wavelength for dental optical coherence tomography (OCT) applications. This HNDF-HPCF offers not only large nonlinear coefficient but also very flat dispersion slope and very low confinement losses. Using these characteristics of our proposed PCF, it is shown through simulations by using finite difference method with an anisotropic perfectly matched boundary layer that this PCF offers the efficient supercontinuum (SC) generation for dental OCT applications at 1.31 μm wavelength using a picosecond pulse easily produced by commercially available less expensive laser sources. Coherent length of light source using SC is found 10 μm and the spatial resolutions in the depth direction for dental applications of OCT are found about 6.1 μm for enamel and 6.5 μm for dentin.     

Sorption and partial molar volumes of C2 and C3 hydrocarbons in polypropylene copolymers

The sorption of C₂ and C₃ hydrocarbons in two ethylene–propylene copolymers and a propylene homopolymer and the simultaneous dilation of the polymers were measured at temperatures of 287–363 K and pressures up to 4 MPa. The sorption isotherms were well described by the Flory–Huggins theory of dissolution. Dilation isotherms in the form of elongation versus pressure were similar in shape to the corresponding sorption isotherms. Solubility coefficients, partial molar volumes, and Flory–Huggins interaction parameters were determined from these isotherms. The thermal expansivities of the hydrocarbons dissolved in the polymers were 0.002–0.005 K^?1, and the Flory–Huggins interaction parameters depended not only on temperature but also on concentration. At 323 K, the calculated solubilities of propylene in the ethylene–propylene‐rubber regions of the copolymers were 1.8 times higher than in the amorphous regions of the propylene homopolymer. © 2001 John Wiley & Sons, Inc. J Polym Sci Part B: Polym Phys 39: 1255–1262, 2001     

The Chemical Constituents of the Liverwort Mylia Nuda

Two diterpenoids, (+)-labda-7,14-dien-13-ol and (+)-manoyl oxide, and one bis(bibenzyl) compound, isomarchantin C, were isolated as the major components from the Taiwanese liverwort Mylia nuda. The spectral evidence is discussed in this paper. In addition, several monoterpenes and sesquiterpenes were also identified by GC/MS.     

Gas sorption in poly(vinyl benzoate)

High-pressure sorption (up to 50 atm) for CO₂, N₂, and Ar in poly(vinyl benzoate) (PVB) was studied at temperatures from 25 to 70°C by a gravimetric method utilizing an electromicrobalance. The results are described by Henry's law above the glass transition temperature T_g for all gases. The dual-mode sorption model, Henry's law plus a Langmuir isotherm, applies to the sorption isotherms of N₂ and Ar in the glassy state, and the dual-mode parameters are given. For CO₂, a new type of sorption isotherm is observed below T_g. The isotherm is concave to the pressure axis in the low-pressure region and turns into a straight line with increasing CO₂ pressure which can be extrapolated back to the coordinate origin. The linear part of the isotherm is characteristic of the rubbery state, while the nonlinear part stems from glassystate behavior. The “glass transition solubility” of CO₂, at which PVB film changes from the glassy to the rubbery state, decrease as the temperature increases. The disappearance of microvoids, that is, the decrease of the Langmuir capacity, may be due to a large plasticizing effect of sorbed CO₂. The difference between the N₂ and Ar isotherms and the CO₂ isotherm is discussed from this standpoint.     

Effects of the Calcination and Reduction Conditions on a Cu/ZnO Methanol Synthesis Catalyst

The CuO crystallite size of the catalysts obtained from aurichalcite greatly depends on the heating rate of calcination for highly active and selective Cu/ZnO catalyst was prepared by reduction with methanol at 443 K for 17 h.